Determining the amount of weighted backlean Measurement B.

The direction that the wedge is facing is where the tree will land. First cut in a downwards direction about halfway into the tree.

Your next cut should be perpendicular to the tree, and lastly upwards. Remove pieces of the wedge as you treegrind.barted Reading Time: 6 mins. As soon as the tree begins falling, remove the saw and use one of the escape routes to get out of the way. If the tree is leaning in the opposite direction, you need to make the back cut in stages, driving wedges as you go to support the trunk to prevent the saw from binding.

Once the back cut extends halfway through the trunk, drive the wedges deeper with a sledgehammer to force the tree in the fall. Nov 30, The easiest choice is to fell the tree in the direction it would naturally fall due to slope, overhang and wind direction. Felling in another direction requires a special technique, more effort, and is sometimes just impossible. Dec 09, Using a Chainsaw 1. Cut on a notch at a degree angle. Decide the direction that you want the tree to fall because this is the side of 2.

Make a horizontal cut ⅓ through the tree. Use the chainsaw and make a clean, horizontal cut at the base of the notch 3. Make a bore cut %(6).